GE Dishwasher Error Code LEAK
LEAK on a GE dishwasher usually means: Possible leak is detected. On a GE Dishwasher, code LEAK points to the leak sensor.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- leak sensor
- Fault type
- leakage
How to fix LEAK — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- The cycle will be cancelled on models with leak detection.
Other GE Dishwasher codes
A possible leak was detected or a control reset is needed. On a GE Dishwasher, code 999 points to the leak protection system.
The drain pump-out exceeded two minutes. On a GE Dishwasher, code C1 points to the drain pump.
The total pump-out cycle exceeded seven minutes. On a GE Dishwasher, code C2 points to the drain pump.
The dishwasher will not drain. On a GE Dishwasher, code C3 points to the drain system.
The unit refilled twice after a power loss, suggesting a stuck or failed float switch.
The pump-out time was too short. On a GE Dishwasher, code C5 points to the drain system.
Search another code
Have a different code? Look it up instantly.