GE Dishwasher Error Code C3
C3 on a GE dishwasher usually means: The dishwasher will not drain. On a GE Dishwasher, code C3 points to the drain system.
Fix it fast: Reset the dishwasher. Full ranked steps below.
- Likely part
- drain system
- Fault type
- drainage
How to fix C3 — ranked steps
Try these in order. Stop when the code clears.
-
1 Reset the dishwasher
Easy- Disconnect power for a minute or two to clear the fault code, then rerun the cycle; if it will still not drain, service is likely required.
-
2 Replace the drain pump
Advanced- If the unit still will not drain after a reset and the sump is clear, disconnect power and water and replace the drain pump.
Parts $86.69 Source
Parts that often fix C3
- Dishwasher Drain Pump with Screws (WD26X10049) ~$86.69 price
Other GE Dishwasher codes
The pump-out time was too short. On a GE Dishwasher, code C5 points to the drain system.
The dishwasher failed to drain. On a GE Dishwasher, code F56 points to the drain system.
The drain pump-out exceeded two minutes. On a GE Dishwasher, code C1 points to the drain pump.
The total pump-out cycle exceeded seven minutes. On a GE Dishwasher, code C2 points to the drain pump.
Failure to drain. On a GE Dishwasher, code FTD points to the drain pump.
A possible leak was detected or a control reset is needed. On a GE Dishwasher, code 999 points to the leak protection system.
Search another code
Have a different code? Look it up instantly.