GE Dishwasher Error Code C1
C1 on a GE dishwasher usually means: The drain pump-out exceeded two minutes. On a GE Dishwasher, code C1 points to the drain pump.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- drain pump
- Fault type
- drainage
How to fix C1 — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- Clean the air gap.
- Replace or reposition the hose.
- Run the disposer to clean it out.
Other GE Dishwasher codes
The total pump-out cycle exceeded seven minutes. On a GE Dishwasher, code C2 points to the drain pump.
Failure to drain. On a GE Dishwasher, code FTD points to the drain pump.
The dishwasher will not drain. On a GE Dishwasher, code C3 points to the drain system.
The pump-out time was too short. On a GE Dishwasher, code C5 points to the drain system.
The dishwasher failed to drain. On a GE Dishwasher, code F56 points to the drain system.
A possible leak was detected or a control reset is needed. On a GE Dishwasher, code 999 points to the leak protection system.
Search another code
Have a different code? Look it up instantly.