GE Dishwasher Error Code C5
C5 on a GE dishwasher usually means: The pump-out time was too short. On a GE Dishwasher, code C5 points to the drain system.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- drain system
- Fault type
- drainage
How to fix C5 — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- Make sure that the water supply is turned on.
- Try the same cycle again.
- Tap on the float cover to un-stick the float.
- This is the plastic cover that looks like an upside down cup in the front left corner of the floor of the dishwasher.
Other GE Dishwasher codes
The dishwasher will not drain. On a GE Dishwasher, code C3 points to the drain system.
The dishwasher failed to drain. On a GE Dishwasher, code F56 points to the drain system.
The drain pump-out exceeded two minutes. On a GE Dishwasher, code C1 points to the drain pump.
The total pump-out cycle exceeded seven minutes. On a GE Dishwasher, code C2 points to the drain pump.
Failure to drain. On a GE Dishwasher, code FTD points to the drain pump.
A possible leak was detected or a control reset is needed. On a GE Dishwasher, code 999 points to the leak protection system.
Search another code
Have a different code? Look it up instantly.