GE Dishwasher Error Code C7
C7 on a GE dishwasher usually means: The water-temperature sensor circuit is inoperative. On a GE Dishwasher, code C7 points to the temperature sensor.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- temperature sensor
- Fault type
- sensor
How to fix C7 — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- Disconnect the power at the circuit breaker for about 30 seconds and then reset the dishwasher.
Other GE Dishwasher codes
The unit refilled twice after a power loss, suggesting a stuck or failed float switch.
A possible leak was detected or a control reset is needed. On a GE Dishwasher, code 999 points to the leak protection system.
The drain pump-out exceeded two minutes. On a GE Dishwasher, code C1 points to the drain pump.
The total pump-out cycle exceeded seven minutes. On a GE Dishwasher, code C2 points to the drain pump.
The dishwasher will not drain. On a GE Dishwasher, code C3 points to the drain system.
The pump-out time was too short. On a GE Dishwasher, code C5 points to the drain system.
Search another code
Have a different code? Look it up instantly.