GE Dishwasher Error Code C6
C6 on a GE dishwasher usually means: The incoming water temperature is too low. On a GE Dishwasher, code C6 points to the water heater.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- water heater
- Fault type
- temperature
How to fix C6 — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- The water temperature coming into the dishwasher should be at least 120 degrees F.
- Run the faucet adjacent to the dishwasher prior to starting the dishwasher to purge any cold water from the line.
- Adjust the water heater temperature.
- Don't use the washing machine or take showers when using the dishwasher.
- Use options on the dishwasher to cause the machine to run longer and thus add more heat.
Other GE Dishwasher codes
A possible leak was detected or a control reset is needed. On a GE Dishwasher, code 999 points to the leak protection system.
The drain pump-out exceeded two minutes. On a GE Dishwasher, code C1 points to the drain pump.
The total pump-out cycle exceeded seven minutes. On a GE Dishwasher, code C2 points to the drain pump.
The dishwasher will not drain. On a GE Dishwasher, code C3 points to the drain system.
The unit refilled twice after a power loss, suggesting a stuck or failed float switch.
The pump-out time was too short. On a GE Dishwasher, code C5 points to the drain system.
Search another code
Have a different code? Look it up instantly.