Whirlpool Dryer Error Code F31
F31 on a Whirlpool dryer usually means: Low or no line voltage was detected. On a Whirlpool Dryer, code F31 points to the power supply.
Fix it fast: Check the power supply. Full ranked steps below.
- Likely part
- power supply
- Fault type
- power
How to fix F31 — ranked steps
Try these in order. Stop when the code clears.
-
1 Check the power supply
Moderate- Confirm the dryer is plugged into a 240 V outlet and that both poles of its double-pole breaker are on, resetting a tripped breaker; with power off, check the terminal-block connections behind the rear panel for loose or burnt screws; if F31 persists, have the outlet voltage tested and a damaged terminal block or cord replaced.
Other Whirlpool Dryer codes
Power failure. On a Whirlpool Dryer, code PF points to the power supply.
Low or no line voltage. On a Whirlpool Dryer, code L2 points to the power supply.
Power unit down by turning off the circuit breaker(s) for 5 minutes. On a Whirlpool Dryer, code E1 points to the power supply.
Power unit down by turning off the circuit breaker(s) for 5 minutes. On a Whirlpool Dryer, code E2 points to the power supply.
Power unit down by turning off the circuit breaker(s) for 5 minutes. On a Whirlpool Dryer, code E3 points to the power supply.
Power unit down by turning off the circuit breaker(s) for 5 minutes. On a Whirlpool Dryer, code F1E1 points to the power supply.
Search another code
Have a different code? Look it up instantly.