JennAir Microwave Error Code FCE1
FCE1 on a JennAir microwave usually means: The appliance could not connect to the router. On a JennAir Microwave, code FCE1 points to the control board.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- control board
- Fault type
- communication
How to fix FCE1 — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- Power appliance down by turning off the circuit breaker(s) for one (1) minute.
- Power appliance up by turning on the circuit breaker(s).
- Monitor the appliance for one (1) minute to ensure the error code does not display again.
- Verify appliance operation.
- Take your smart device to the appliance location to verify operation.
- If you are not receiving a strong wireless signal, there are a few things you can try:
- Move your router to a different location in your home
- Obtain a compatible signal extender, or
- Contact your Internet Service Provider
Frequently asked questions
What does JennAir Microwave error FCE1 mean?
The appliance could not connect to the router. On a JennAir Microwave, code FCE1 points to the control board.
Which part is usually at fault for JennAir error FCE1?
The most commonly implicated component is the control board.
What is the first thing to try for JennAir error FCE1?
Power appliance down by turning off the circuit breaker(s) for one (1) minute. Power appliance up by turning on the circuit breaker(s). Monitor the appliance for one (1) minute to ensure the error code does not display again. Verify appliance operation. Take your smart device to the appliance location to verify operation. If you are not receiving a strong wireless signal, there are a few things you can try: Move your router to a different location in your home Obtain a compatible signal extender, or Contact your Internet Service Provider
Other JennAir Microwave codes
The appliance could not connect to the router. On a JennAir Microwave, code FCE2 points to the control board.
The appliance could not connect to the router. On a JennAir Microwave, code FCE3 points to the control board.
The Keypad (User Interface) reported a problem to the control board. On a JennAir Microwave, code E03 points to the control board.
The Gas Sensor reported a problem to the control board. On a JennAir Microwave, code E11 points to the control board.
The Thermal Sensor circuit reported open to the control board. On a JennAir Microwave, code E21 points to the control board.
The Thermal Sensor circuit reported a short to the control board. On a JennAir Microwave, code E22 points to the control board.
Search another code
Have a different code? Look it up instantly.