Error E01 Stops machine UK market
Hoover Washing Machine Error Code E01
E01 on a Hoover washing machine usually means: The door lock (or drum-brake safety device on older collector-motor models) is not engaging correctly.
Fix it fast: Check the door and reset. Full ranked steps below.
- Likely part
- door interlock
- Fault type
- door lock
How to fix E01 — ranked steps
Try these in order. Stop when the code clears.
-
1 Check the door and reset
Easy- Close the door firmly until it clicks, clear debris from the seal, and disconnect power for five to ten minutes before retrying.
-
2 Replace the door lock
Pro only- If the error persists, have the interlock tested for continuity during the lock command and the door lock assembly replaced; check the control board if it continues.
Other Hoover Washing Machine codes
E02Stops machine
The machine is not filling within the expected time. On a Hoover Washing Machine, code E02 points to the water inlet valve.
E03Stops machine
The machine is not draining within the expected time. On a Hoover Washing Machine, code E03 points to the drain pump.
E05Degraded
A heating circuit fault in the element or relay was detected.
Search another code
Have a different code? Look it up instantly.