Frigidaire Washing Machine Error Code E4
E4 on a Frigidaire washing machine usually means: The unit is out of balance during spin operation. On a Frigidaire Washing Machine, code E4 points to the sensor.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- sensor
- Fault type
- sensor
How to fix E4 — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- Check to ensure the washer is resting firmly on floor. Adjust leveling legs. Note: This is a common Installation Issue. If the unit was installed or has been moved in the past 30 days, refer to the installer.
- Foam shipping support may not have been removed during installation. Note: See installation instructions for removing foam shipping support.
- Make sure that the laundry load is balanced. During the spin process, if clothes are piled up at one side of the basket, it will stop due out of balance. The unit will try to solve the problem automatically. If the washer cannot solve the problem in three attempts, redistribute the clothes.
Other Frigidaire Washing Machine codes
Wash lid is either open or the lid lock failed. On a Frigidaire Washing Machine, code E3 points to the sensor.
The fill time is too long. On a Frigidaire Washing Machine, code E11 points to the water inlet valve.
Water is not pumping out fast enough. On a Frigidaire Washing Machine, code E21 points to the drain pump.
Water is not entering washer or slow water fill time. On a Frigidaire Washing Machine, code E1 points to the inlet valve.
Water takes too long to drain or is not draining properly. On a Frigidaire Washing Machine, code E2 points to the drain pump.
The unit is not level. On a Frigidaire Washing Machine, code E5 points to the vibration sensor.
Search another code
Have a different code? Look it up instantly.