Bosch Washing Machine Error Code E30
E30 on a Bosch washing machine usually means: This error code could be caused by a number of issues — please check the following:The water pressure is low. On a Bosch Washing Machine, code E30 points to the drain pump.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- drain pump
- Fault type
- drainage
How to fix E30 — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- Contact your plumber if the water pressure is too low.
- The filters in the water inlet are blocked.
- Clean the filters in the water inflow.
- The faucet is turned off.
- Turn on the faucet.
- The water inlet hose is kinked or jammed.
- Ensure that the water inlet hose is not kinked or jammed.
- The water level measurement system is defective.
- Wait approximately 5 minutes until the draining process has ended.
- To reset the fault message, switch off the appliance.
Other Bosch Washing Machine codes
The pump is blocked (obstructed). On a Bosch Washing Machine, code E0018 points to the drain pump.
This error code could be caused by a number of issues — please check the following:The drain pipe or water outlet hose is blocked. On a Bosch Washing Machine, code E3610 points to the drain pump.
The drain pump is blocked. On a Bosch Washing Machine, code E38 points to the drain pump.
The door is not locked properly. On a Bosch Washing Machine, code E16 points to the door lock.
The filters in the water connection or AquaStop hose are blocked or the water pressure is too low. On a Bosch Washing Machine, code E17 points to the inlet valve.
The pump for the intelligent dosing system is blocked. On a Bosch Washing Machine, code E10 points to the sensor.
Search another code
Have a different code? Look it up instantly.