Whirlpool Dryer Error Code ERR
ERR on a Whirlpool dryer usually means: You will receive the "ERR" error code when the door has not been completely closed and latched; the dryer will not run unless the door is closed. On a Whirlpool Dryer, code ERR points to the door lock.
Fix it fast: Manufacturer troubleshooting steps. Full ranked steps below.
- Likely part
- door lock
- Fault type
- mechanical
How to fix ERR — ranked steps
Try these in order. Stop when the code clears.
-
1 Manufacturer troubleshooting steps
DIY- Your dryer door may not be fully closed. It may look shut but may not be latched.
- Push on the door to engage the latch or latches.
- Some models have an upper and lower latch. Both latches must be secure for the dryer to run.
- Power unit down by turning off the circuit breaker(s) for one (1) minute.
- Power unit up by turning on the circuit breaker(s).
- Start a time dry cycle.
- Monitor the dryer for one (1) minute to ensure the error code does not display again.
Other Whirlpool Dryer codes
A door lock fault was detected. On a Whirlpool Dryer, code F06 points to the door lock.
Restricted airflow. On a Whirlpool Dryer, code AF points to the fan.
The primary control board failed. On a Whirlpool Dryer, code F01 points to the control board.
The keypad or user interface failed. On a Whirlpool Dryer, code F02 points to the keypad.
A heating element fault was detected. On a Whirlpool Dryer, code F20 points to the heating element.
A communication fault was detected. On a Whirlpool Dryer, code F24 points to the control board.
Search another code
Have a different code? Look it up instantly.